Foreign, Configuration view – Dell PowerEdge RAID Controller 6i User Manual

Page 103

Advertising
background image

Configuring and Managing RAID

103

Controller Management Actions

Table 6-6 describes the actions you can perform on the Ctrl Mgmt screen.

Foreign Configuration View

When a foreign configuration is present, you can select Foreign
Configuration View to display the configuration. This screen shows the
foreign configuration as it would be if you import it. You can preview the
foreign configuration before you decide whether to import it or clear it.

In some cases, a foreign configuration cannot be imported. If a physical disk
in a virtual disk is rebuilding, the physical disk's state is set to Rebuild. For
the virtual disks, the text Importable or Not Importable displays next to each
virtual disk. No virtual disk target ID displays for virtual disks that cannot be
imported.

Table 6-6.

Controller Management Options

Option

Description

Enable Controller
BIOS

Select this option to enable the controller BIOS. If the boot
device is on the RAID controller, the BIOS must be enabled.
Disable the BIOS to use other boot devices.

In a multiple controller environment, you can enable BIOS on
multiple controllers. However, if you want to boot from a
specific controller, then enable the BIOS on that controller
and disable it on the other controllers. The system can then
boot from the BIOS-enabled controller.

Enable Alarm

Select this option to enable or disable the audible alarm on
the controller, if alarm hardware is present. The alarm sounds
to warn you of any problems with the physical disks or the
virtual disks.

Enable BIOS Stop
On Error

Select this option to stop the system BIOS during bootup if
there are BIOS errors. This option enables you to enter the
configuration utility to resolve the problem.

Select Bootable VD

Select this option to specify a virtual disk as the boot disk on
the controller. This option displays if you have built virtual
disks.

Factory Default

Select this option to restore the default settings for the
options in the Settings box.

Dell_PERC6.1_UG.book Page 103 Wednesday, April 15, 2009 4:18 PM

Advertising