Dell PowerEdge RAID Controller 6i - Manual (Page 54)

54
Installing and Configuring Hardware
CAUTION:
Running a system without the system cover installed can cause
damage due to improper cooling.
3 Remove the TBBU assembly from the adapter by pressing down on the
tabs at each edge of the DIMM connector and lifting the TBBU off the
adapter.
4 Disconnect the battery cable from the DIMM.
5 Detach the battery from the DIMM by pressing out on the battery clips
inserted through the DIMM and rotating the battery off the DIMM.
See Figure 4-10.
Figure 4-10. Removing the TBBU
1 memory module 2 battery
2
1
Dell_PERC6.1_UG.book Page 54 Wednesday, April 15, 2009 4:18 PM