Dell PowerEdge 7250 - Manual (Page 17)

Configuring Your Managed System 15
Flow Control No Flow Control
[CTS/RTS]
CTS/RTS + CD
XON/XOFF
No flow control.
CTS/RTS = Hardware-based flow control.
CTS/RTS +CD = Hardware-based + carrier-detect flow
control. When the BMC Management Utility is sharing
the COM port as console redirection, the flow control
must be set to CTS/RTS or CTS/RTS+CD depending
on whether a modem is used.
Xon/Xoff = Software-based flow control.
Terminal Type [PC-ANSI]
VT100+
VT-UTF8 Select terminal type. VT100+ only available when
English selected as the language. VT-UTF8 uses
UNICODE. PC-ANSI is the standard PC-type terminal.
Serial Port COM2 2F8 IRQ3 Hardcoded – no selection available. Note that if Console
Redirection is enabled, then the Base I/O address and
IRQ selection of Serial Port B (under Menu Advanced,
submenu Peripheral Configuration) should match this
Serial Port setting under the Console Redirection
submenu.
Remote Console Reset Enabled/Disabled Enables remote reset using escape key sequence;
<ESC> <R> <ESC> <r> <ESC> <R>
ACPI OS Headless
Operation
Disabled
Same as BIOS
Serial Port Used to pass information about serial redirection to
ACPI OS.
ACPI OS Baud Rate 9600
19.2k
38.4K
57.6k
115.2k Only available when ACPI OS Headless Operation is
same as BIOS or Serial Port.
ACPI OS Flow Control No Flow Control
CTS/RTS
XON / XOFF
CTS/RTS + CD
Only available when ACPI OS Headless Operation is
same as BIOS or Serial Port.
ACPI OS Terminal
Type
PC-ANSI
VT100+
VT-UTF8 Only available when ACPI OS Headless Operation is
same as BIOS or Serial Port.
Table 2-2. Setup Console Redirection Submenu Items (continued)
Submenu Item Default Value Description