Dell PowerEdge 7250 - Manual (Page 32)

30 BMC Management Utility
www
.del
l.
com |
su
ppo
rt.
d
e
ll.
co
m The SOL Proxy will start automatically during system startup. Alternatively, you can go to directory
/etc/init.d and use the following command to manage the SOL Proxy service:
solproxy status
solproxy start
solproxy stop
solproxy restart
Uninstalling the BMC Management Utility
To uninstall the BMC Management Utility, perform the following procedures:
1 Log in as root.
2 Enter the following command to remove all the installed packages.
rpm -e osabmcutil
3 If you receive a success message, it shows that the BMC Management Utility is uninstalled.
IPMI Shell
IPMI Shell is a CLI console application and has no graphical user interface. Its commands and
options are specified using command line arguments only.
IPMI Shell supports out-of-band (OOB) access (over a LAN or through the serial port) to a single
system at a time, however, multiple IPMI Shell sessions can run simultaneously on the same
managed system. SeeFigure 3-2.
IPMI Shell allows a user with user-level BMC user privileges to:
• Display the current power status
• Display the 16-byte system GUID of the managed system
• Display all field replaceable units (FRU) present in the system
• Display the BMC firmware information
• Display summary information about the event log
• Display the logged events
In addition to the operations that can be performed by a user with user-level BMC user privileges,
IPMI Shell allows a user with operator-level BMC user privileges to:
• Power on, reset, or cycle a managed system
• Simulate a hard power off a managed system (forcing the system to turn off without shutting
down the operating system)
• Delete the system event log (SEL)
• Turn on/off the blinking system identification LED