Dell PowerEdge 7250 - Manual (Page 84)

82 Terminal Mode Commands
www
.del
l.
com |
su
ppo
rt.
d
e
ll.
co
m
Boot flags
(semi-volatile)
(continued)
5 Data 3
[7] - 1b = Lock out (power off/ sleep request) using the Power
Button.
[6:5] - Firmware (BIOS) Verbosity (Directs what appears on POST
display).
00b = System default.
01b = Request quiet display.
10b = Request verbose display.
11b = Reserved.
[4] - 1b = Force progress event traps. When set to 1b, the BMC
transmits PET traps for BIOS progress events to the LAN or
serial/modem destination for the session that set the flag. Since
this capability uses PET traps, this bit is ignored for connection
modes that do not support PET such as Basic Mode and Terminal
Mode.
[3] - 1b = User password bypass. When set to 1b, the managed
client’s BIOS boots the system and bypasses any user or boot
password that might be set in the system.
[2] - 1b = Lock Sleep Button. When set to 1b, directs BIOS to
disable the sleep button operation for the system, normally until
the next boot cycle.
[1:0] -00b = Console redirection occurs per BIOS configuration
setting.
01b = Suppress (skip) console redirection if enabled.
10b = Request console redirection be enabled.
11b = Reserved.
Table C-5. Boot Option Parameters (continued)
Parameter Number Parameter Data (non-volatile unless otherwise noted)