Dell PowerEdge 7250 - Manual (Page 77)

Terminal Mode Commands 75
SYS SET TCFG Returns the Terminal Mode Configuration bytes where XX and YY
represent hex-ASCII encoding for the volatile version of data bytes
1 and 2 as specified in Table C-6, and AA BB represent hex-ASCII
encoding of the non-volatile version.
V:XX Output termination sequence>
N:AA BB <output termination sequence>
-V XX YY This command sets the volatile Terminal Mode Configuration. XX
and YY represent hex-ASCII encoding for data bytes 1 and 2 as
specified in Table C-6. The BMC returns the same output as for
SYS SET TCFG, above.
-N XX YY This command sets the non-volatile Terminal Mode
Configuration. XX and YY represent hex-ASCII encoding for data
bytes 1 and 2 as specified in Table C-6. The BMC returns the same
output as for SYS SET TCFG, above.
SYS RESET Directs the BMC to perform an immediate system hard reset.
SYS POWER
OFF
Directs the BMC to perform an immediate system power off.
SYS POWER ON Causes the BMC to initiate an immediate system power on.
Table C-4. Terminal Mode Text Commands (continued)
Command Switches Description