Charger board, Removing the charger board, Replacing the charger board – Dell Studio 1735 (Mid 2008) User Manual
Page 13
Back to Contents Page
Charger Board
Dell™ Studio 1735/1737 Service Manual
Removing the Charger Board
1.
Follow the procedures in
Before You Begin
.
2.
Press and eject any installed cards from the ExpressCard slot and the 8-in-1 memory card reader.
3.
Remove any installed memory modules and Mini-Cards (see
Memory
and
Communication Cards
).
4.
Follow the instructions in
Removing the System Board
.
5.
Remove the two screws that secure the charger board to the computer base.
6.
Lift the charger board out of the computer base.
Replacing the Charger Board
1.
Place the charger board in the computer base.
2.
Replace the two screws that secure the charger board to the computer base.
3.
Follow the instructions in
Replacing the System Board
.
Back to Contents Page
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1
screw (2)
2
charger board
3
USB connector (2)
4
AC adapter connector