Keyboard, Removing the keyboard – Dell Studio 1735 (Mid 2008) User Manual
Page 29
Back to Contents Page
Keyboard
Dell™ Studio 1735/1737 Service Manual
Removing the Keyboard
1.
Follow the procedures in
Before You Begin
.
2.
Remove the Center Control Cover (see
Removing the Center Control Cover
).
3.
Ease the keyboard surround up with a plastic scribe.
4.
Lift the keyboard surround off the computer.
5.
Remove the four screws at the top of the keyboard.
6.
Carefully slide the keyboard out of the computer and turn it over as shown in the illustration. Do not pull hard on the keyboard.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1
keyboard surround
NOTICE:
The keycaps on the keyboard are fragile, easily dislodged, and time- consuming to replace. Be careful when removing and handling the
keyboard.
NOTICE:
Be extremely careful when removing and handling the keyboard. Failure to do so could result in scratching the display panel.