Communication cards, Subscriber identity module, Wireless mini-cards – Dell Studio 1735 (Mid 2008) User Manual
Page 35: Installing the sim, Removing the sim
Back to Contents Page
Communication Cards
Dell™ Studio 1735/1737 Service Manual
Subscriber Identity Module
Subscriber Identity Modules (SIM) identify users uniquely through an International Mobile Subscriber Identity.
Installing the SIM
1.
Follow the procedures in
Before You Begin
.
2.
In the battery bay, slide the SIM into the compartment.
Removing the SIM
1.
Press the SIM eject bar to release the SIM.
2.
When it is partially ejected, remove the SIM from the battery bay.
Wireless Mini-Cards
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer supports three Mini-Card slots:
l
two Full Mini-Card slots – for WWAN, WPAN, UWB, Bluetooth
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
Only GSM (HSDPA) type cards need a SIM. EVDO cards do not use a SIM.
1
SIM eject bar
2
battery bay
3
SIM
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is
not covered by your warranty.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.