Dell Studio 1735 (Mid 2008) - Manual (Page 24)

1. Replace the screw that secures the inverter board.
2. Connect the cables to the connectors on either side of the inverter board.
3. Replace the display bezel (see Replacing the Display Bezel ).
4. Follow the instructions in Replacing the Display Assembly .
Display Hinges
Removing the Display Hinges
1. Follow the instructions in Display Assembly .
2. Remove the display bezel (see Display Bezel ).
3. Remove the display panel (see Removing the Display Panel ).
4. Remove the four screws (two on each side) that secure the hinges to the display cover and remove the hinges.
Replacing the Display Hinges
1. Replace the hinges and replace the four screws (two on each side) that secure the hinges to the display cover.
2. Replace the display panel (see Replacing the Display Panel ).
3. Replace the display bezel (see Replacing the Display Bezel ).
4. Follow the instructions in Replacing the Display Assembly .
Back to Contents Page
1 screw (4 total; 2 on each side) 2 hinge (1 left, 1 right)