Speakers, Removing the speakers, Replacing the speakers – Dell Studio 1735 (Mid 2008) User Manual
Page 43
Back to Contents Page
Speakers
Dell™ Studio 1735/1737 Service Manual
Removing the Speakers
1.
Follow the instructions in
Before You Begin
.
2.
Press and eject any installed cards from the ExpressCard slot and the 8-in-1 memory card reader.
3.
Remove any installed memory modules and Mini-Cards (see
Memory
and
Communication Cards
).
4.
Follow the instructions in
Display Assembly
.
5.
Remove the four speaker screws (two on each speaker) from the computer base.
6.
Remove the palm rest (see
Removing the Palm Rest
).
7.
Make note of the speaker cable routing.
8.
Remove the speakers and the cable.
Replacing the Speakers
1.
Replace the speakers and the speaker cable.
2.
Connect the speaker cable to the connector on the system board.
3.
Replace the four speaker screws (two on each speaker) that secure the speakers to the palm rest.
4.
Replace the palm rest (see
Replacing the Palm Rest
).
5.
Follow the instructions in
Replacing the Display Assembly
.
6.
Reinstall the memory modules and Mini-Cards, if any.
7.
Reinstall any removed cards in the ExpressCard and 8-in-1 card slots.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as the back panel) on the computer.
1
screw (4)
2
speaker cable
3
speaker (2)