Dell Brocade Adapters - Manual (Page 151)

Brocade Adapters Troubleshooting Guide 127
53-1002145-01
Appendix
B
HCM and Installer Message Reference
This appendix provides details on messages that display during operation of the Host Connectivity
Manager (HCM) and Brocade Adapter Software Installer program. The following tables in this
appendix provide reasons why these messages display and actions that you should take to resolve
any problems associated with the messages:
• Table 14 provides details on messages that display during operation of the Host Connectivity
Manager (HCM). Causes for each message and actions that you should perform are provided.
• Table 15 on page 137 provides details on messages that display during operation of the
Brocade Adapter Software Installer program. Causes for each message and actions that you
should perform are provided.
TABLE 14 Host Connectivity Manager messages
Message Cause Corrective Action or Notes
A maximum of eight
ports are allowed in a
team. Occurs when the user tries to create a team
with more than eight ports. Create a team with eight or fewer
ports.
A maximum of three IP
addresses are allowed. Occurs when more than three IP addresses are
entered in the Syslog Server Configuration
dialog box. Configure three or less IP
addresses.
Add Team failed.
<Runtime Reason> Occurs when addition of team failed due to
runtime error.
•
Refer to the runtime reason.
•
Refer to HCM logs.
•
Verify if the team was already
added.
Add Team failed. Given
adapter is part of
another Team or VLANS
exist. Occurs when the user tries to create a team
using an adapter for which are VLANs
configured. Do not create team when VLANs are
configured.
After driver file upload,
older agent is
stopped.\nDriver update
is started. Older Agent stops after the driver upload. Information message.
Add Team failed due to
an unexpected error.
<Runtime Reason> Adding a team failed due to an unexpected
error. Determine why the error happens
when adding a team.
All pending test(s) will be
stopped. Started test(s)
will continue to run until
they are finished. Do you
really want to close the
window? Occurs when the user stops a diagnostics test
before it finishes. Do not stop the test until it finishes.