Dell POWEREDGE M1000E - Manual (Page 66)

46 Fabric Watch Administrator’s Guide
53-1002752-01
thConfig command
6
Table 11 provides default settings for areas in the End-to-End Performance Monitor class.
thConfig command
You can use the thConfig command to customize event monitoring thresholds for the Fabric,
Security, SFP, and Performance classes or to display the configuration. It is recommended,
however, that you use the default settings for these classes.
If configured areas exceed the currently-effective threshold settings, the Fabric Watch daemon can
take one of the following actions:
• Send an SNMP alarm.
• Log a RASlog message.
• Send an e-mail alert.
For complete information about using the thConfig command, refer to the Fabric OS Command
Reference Manual.
TABLE 11 End-to-End Performance Monitor class default settings
Area Description Default threshold settings Default alarm
settings
Threshold state
End-to-end receive
performance
(RX performance) Monitors the
receiving traffic
between a SID_DID
pair in a port Unit: KBps
Time Base: none
Low: 0
High: 0
Buffer: 0 Below: 0
Above: 0 Informative
Informative
End-to-end transmit
performance
(TX performance) Monitors the transmit
traffic between a
SID_DID pair in a port Unit: KBps
Time Base: none
Low: 0
High: 0
Buffer: 0 Below: 0
Above: 0 Informative
Informative