Dell POWEREDGE M1000E - Manual (Page 71)

Fabric Watch Administrator’s Guide 51
53-1002752-01
thConfig command
6
Displaying the number of 16 Gbps SFP operational hours
To show the number of hours that the 16 Gbps SFP is operational, enter the thConfig command
using the following parameter. Note that the only supported timebase for this area is none.
switch:admin> thconfig
--
show sfp -area PWRONHRS -sfptype 16GSWL
Displaying the SFP health information
The sfpshow command displays the health of 10 and 16 Gbps SFPs and the QSFP.
Enter the sfpshow command using the following parameter:
switch:admin> sfpshow
--
health
Fabric Watch monitors the SFP’s current, voltage, receiver (RXP), and transmitter (TXP) and if any of
these parameters crosses the low or high thresholds, the state of the SFP is yellow; otherwise, the
state is green. The SFP can also be in one of the following states:
• Paused—health monitoring is not enabled.
• No license—the switch does not have the Fabric Watch license.
• Unknown—Fabric Watch cannot determine the state of the SFP.
Others N/A Temperature (Centigrade) 85 -10
Voltage (mVoltage) 3630 2970
RXP (uW) 5000 0
TXP (uW) 5000 0
Current (mAmp) 50 0
TABLE 13 16 Gbps and QSFP configurable SFP types (Continued)
SfpType Serial number Area Default Value