Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 15)

size in all banks; faulty
memory module(s).
properly installed. If the problem persists, see
" Troubleshooting System Memory " in
"Troubleshooting Your System."
Alert! Unsupported memory or incomplete
sets in the following bank(s): Bank x Memory modules installed
in the specified bank are
not the same type and
size; faulty memory
module(s).
Ensure that all banks contain memory modules
of the same type and size and that they are
properly installed. If the problem persists, see
" Troubleshooting System Memory " in
"Troubleshooting Your System."
Amount of available memory limited to
256 MB! OS Install Mode is
enabled in the System
Setup program.
Disable OS Install Mode in the System Setup
program (see "Using the System Setup
program" in the User's Guide).
Auxiliary device failure Loose or improperly
connected mouse or
keyboard cable; faulty
mouse or keyboard.
See " Troubleshooting the Mouse " and
" Troubleshooting the Keyboard " in
"Troubleshooting Your System."
BIOS Update Attempt Failed! Remote BIOS update
attempt failed.
Retry the BIOS update. If problem persists, see
" Getting Help ."
CD-ROM drive not found Improperly connected or
missing CD drive.
See " Troubleshooting a CD Drive " in
"Troubleshooting Your System."
CPUs with different cache sizes
detected Microprocessors with
different cache sizes are
installed.
Ensure that all microprocessors have the same
cache size and that they are properly installed
(see " Adding or Replacing a Microprocessor " in
"Installing System Options").
Decreasing available memory Faulty or improperly
installed memory modules.
See " Troubleshooting System Memory " in
"Troubleshooting Your System."
Diskette drive n seek failure Incorrect configuration
settings in the System
Setup program.
Run the System Setup program to correct the
settings (see "Using the System Setup
Program" in the User's Guide).
Faulty or improperly
installed diskette drive.
See " Troubleshooting the Diskette Drive " in
"Troubleshooting Your System."
Diskette read failure Faulty or improperly
inserted diskette.
Replace the diskette.
Diskette subsystem reset failed Faulty or improperly
installed diskette drive.
See " Troubleshooting the Diskette Drive " in
"Troubleshooting Your System."
ECC memory error Faulty or improperly
installed memory modules.
See " Troubleshooting System Memory " in
"Troubleshooting Your System."
Remote access controller error
Remote access controller is not present
Embedded remote access
memory may be
temporarily corrupted.
To clear the embedded remote access
memory, shut down the system, disconnect
the power cords, wait approximately 30
seconds, reconnect the power cords, and
restart the system. If the problem persists, see
" Getting Help ."
Error: Maximum PCI option ROM count
exceeded! Too many expansion cards
have ROM enabled in the
System Setup program.
Disable ROM for some of the expansion cards.
See "Using the System Setup Program" in the
User's Guide.
Gate A20 failure Faulty keyboard controller;
faulty system board.
See " Getting Help ."
Hard disk controller failure
Hard disk read failure
Incorrect configuration
settings in System Setup
program; improperly
installed hard drive, or
loose interface or power
cable; faulty hard-drive
controller subsystem.
Run the System Setup program to correct the
drive type (see "Using the System Setup
Program" in the User's Guide). If the problem
persists, see " Troubleshooting Hard Drives " in
"Troubleshooting Your System."
I/O parity interrupt at address Faulty or improperly
installed expansion card.
See " Troubleshooting Expansion Cards " in
"Troubleshooting Your System."