Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 16)

Invalid configuration information -
please run SETUP program Incorrect configuration
settings in System Setup
program; NVRAM_CLR
jumper is installed; faulty
system battery.
Check the System Setup configuration settings
(see "Using the System Setup Program" in the
User's Guide). Remove the NVRAM_CLR jumper
(see Figure A-2 for jumper location). If the
problem persists, see " Troubleshooting the
System Battery " in "Troubleshooting Your
System."
Invalid NVRAM configuration, resource
re-allocated System configuration data
has been ignored.
Check the System Setup configuration settings.
See "Using the System Setup Program" in the
User's Guide.
Invalid SCSI configuration
SCSI cable detected on connector SCSIB
of the SCSI backplane, daughter card
not present
A SCSI cable is connected
to the channel B connector
on the SCSI backplane
board; SCSI backplane
daughter card is not
installed.
If a cable is connected to the SCSIB backplane
board connector, the SCSI backplane daughter
card must be installed. Install the backplane
daughter card (see " Installing a SCSI
Backplane Daughter Card " in "Installing
Drives").
Keyboard controller failure Faulty keyboard controller;
faulty system board.
See " Getting Help ."
Keyboard clock line failure Loose or improperly
connected keyboard cable;
faulty keyboard; faulty
keyboard controller.
See " Troubleshooting the Keyboard " in
"Troubleshooting Your System."
Keyboard data line failure
Keyboard failure
Keyboard stuck key failure
Memory address line failure at address,
read value expecting value Faulty or improperly
installed memory modules.
See " Troubleshooting System Memory " in
"Troubleshooting Your System."
Memory double word logic failure at
address, read value expecting value
Memory high address line failure at
start address to end address
Memory high data line failure at start
address to end address
Memory odd/even logic failure at start
address to end address
Memory write/read failure at address,
read value expecting value
Memory parity failure at start address
to end address
Memory parity error at address
Faulty or improperly
installed memory modules.
See " Troubleshooting System Memory " in
"Troubleshooting Your System."
No boot device available Faulty or missing
CD/diskette drive
subsystem, hard drive, or
hard-drive subsystem.
Use a bootable diskette, CD, or hard drive. If
the problem persists, see " Troubleshooting the
Diskette Drive ," " Troubleshooting a CD Drive ,"
and " Troubleshooting Hard Drives " in
"Troubleshooting Your System."
No boot sector on hard- disk No operating system on
hard drive.
Check the hard-drive configuration settings in
the System Setup program (see "Using the
System Setup Program" in the User's Guide).
No PXE-capable device available <F12> pressed during
POST and no PXE devices
are detected.
Check the configuration settings in the System
Setup program for the NICs (see "Using the
System Setup Program" in the User's Guide). If
the problem persists, see " Troubleshooting the
NICs " in "Troubleshooting Your System."
No timer tick interrupt Faulty system board. See " Getting Help ."
Not a boot diskette No operating system on
diskette.
Use a bootable diskette.
PCI BIOS failed to install Loose cables to expansion
card(s); faulty or
improperly installed
expansion card.
Ensure that all appropriate cables are securely
connected to the expansion cards. If the
problem persists, see " Troubleshooting
Expansion Cards " in "Troubleshooting Your
System."
Plug & Play Configuration Error Error encountered in Install the NVRAM_CLR jumper and reboot the