Dell Latitude LM - Manual (Page 113)

Regulatory Notices C-3
Note that Industry Canada regulations provide that
changes or modifications not expressly approved by Dell
Computer Corporation could void your authority to oper-
ate this equipment.
Canadian Modem Requirements
The ICES label identifies certified equipment. This certi-
fication means the equipment meets certain
telecommunications network protective, operational, and
safety requirements. The Industry Canada regulations do
not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, ensure that it is permis-
sible to be connected to the facilities of the local
telecommunications company. The equipment must also
be installed using an acceptable method of connection. In
some cases, the company's inside wiring associated with
a single-line individual service may be extended by
means of a certified connector assembly (telephone
extension cord). Be aware that compliance with these
conditions may not prevent degradation of service in
some situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by
the supplier (in this case, Dell Computer Corporation).
Any repairs or alterations made to this equipment, or
equipment malfunctions, may give the telecommunica-
tions company cause to request that you disconnect the
equipment.
For your own protection, ensure that the electrical ground
connections of the power utility, telephone lines, and
internal metallic water pipe system, if present, are con-
nected together. This precaution may be particularly
important in rural areas.
E
N 55022 Compliance (Czech
Republic Only)
C
E Notice
Marking by the symbol indicates compliance of
this Dell system to the EMC (Electromagnetic Compati-
bility) directive of the European Community. Such
marking is indicative that this Dell system meets or
exceeds the following technical standards:
• EN 55022 — “Limits and Methods of Measurement
of Radio Interference Characteristics of Information
Technology Equipment.”
NOTE: EN 55022 emissions requirements provide
for two classifications—Class A and Class B. If any
one of the registration labels (located on the bottom
or back panel of your computer, on card-mounting
brackets, or on the cards themselves) carries an
FCC Class A rating, the following warning applies
to your system.
This Class B (or Class A, if so indicated on the regis-
tration label) digital apparatus meets the requirements
of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la Classe B (ou Classe A, si
ainsi indiqué sur l’étiquette d’enregistration) respecte
toutes les exigences du Reglement sur le Materiel
Brouilleur du Canada.
This device belongs to category B devices as
described in EN 55022, unless it is specifically stated
that it is a category A device on the specification label.
The following applies to devices in category A of EN
55022 (radius of protection up to 30 meters). The user
of the device is obliged to take all steps necessary to
remove sources of interference to telecommunication
or other devices.
Pokud není na typovém stítku pocítace uvedeno, ze
spadá do trídy A podle EN 55022, spadá automaticky
do trídy B podle EN 55022. Pro zarízení zarazená do
trídy A (ochranné pásmo 30m) podle EN 55022 platí
následující. Dojde-li k rusení telekomunikacních nebo
jinych zarízení, je uzivatel povinen provést taková
opatrení, aby rusení odstranil.
CAUTION: This is a Class A product. In a
domestic environment this product may cause
radio interference in which case the user may
be required to take adequate measures.