Installing a raid battery, Figure 3-15, See figure 3-15 – Dell PowerEdge T410 User Manual
Page 120
120
Installing System Components
Figure 3-15.
Removing and Installing the RAID Battery
Installing a RAID Battery
1 Insert the RAID battery into the battery carrier. See Figure 3-15.
2 Align the tabs on the battery carrier with the battery carrier slots
on the chassis.
3 Slide the battery carrier into the battery carrier slots until it locks into
4 Connect the battery cable to the connector on the storage card and replace
the storage controller card. See "Installing an Expansion Card" on page 115.
5 Hold the touch points and lower the expansion card stabilizer.
6 Close the system. See "Closing the System" on page 91.
7 Place the system upright and on its feet on a flat, stable surface.
1
RAID battery
2
battery cable connector
3
battery carrier tabs
4
battery carrier slots (2)
5
battery carrier
6
battery carrier release tab
5
3
2
4
1
6
book.book Page 120 Tuesday, June 9, 2009 4:09 PM