Dell PowerEdge T410 - Manual (Page 36)

36
About Your System
E2010 Memory not
detected.
Inspect DIMMs.
No memory was detected
in the system. Install or reseat memory
modules. See "Installing
Memory Modules" on
page 110 or
"Troubleshooting System
Memory" on page 162.
E2011 Memory
configuration
failure. Check
DIMMs.
Memory detected, but is
not configurable. Error
detected during memory
configuration. See "Troubleshooting
System Memory" on
page 162.
E2012 Memory
configured but
unusable.
Check DIMMs.
Memory configured, but is
unusable. See "Troubleshooting
System Memory" on
page 162.
E2013 BIOS unable to
shadow memory.
Check DIMMs.
The system BIOS failed to
copy its flash image into
memory. See "Troubleshooting
System Memory" on
page 162.
E2014 CMOS RAM
failure. Power
cycle AC.
CMOS failure. CMOS
RAM not functioning
properly. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
E2015 DMA Controller
failure. Power
cycle AC.
DMA controller failure. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
E2016 Interrupt
Controller
failure. Power
cycle AC.
Interrupt controller
failure. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
Table 1-2. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 36 Tuesday, June 9, 2009 4:09 PM