Dell PowerEdge T410 - Manual (Page 136)

136
Installing System Components
9 Gently lift the heat sink off of the processor and set the heat sink aside
with the thermal grease side facing up.
CAUTION:
The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
10 Position your thumb firmly over the processor socket-release lever and
release the lever from the locked position. Rotate the lever 90 degrees
upward until the processor is released from the socket. See Figure 3-23.
Figure 3-22. Installing and Removing the Heat Sink
1 heat sink 2 heat-sink retention screws (4)
1
2
book.book Page 136 Tuesday, June 9, 2009 4:09 PM