Cooling shroud, Removing the cooling shroud – Dell PowerEdge T410 User Manual

Page 92

Advertising
background image

92

Installing System Components

8 Reattach any peripherals and connect the system to an electrical outlet.
9 Turn on the system and attached peripherals.

Cooling Shroud

The cooling shroud directs airflow over the system processor and memory
modules.

WARNING:

Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.

WARNING:

The memory modules and heat sink can get very hot during normal

operation. Ensure that the memory modules and heat sink have had sufficient time
to cool before you touch it.

CAUTION:

Never operate your system with the cooling shroud removed.

Overheating of the system can develop quickly, resulting in shutdown of the
system and loss of data.

Removing the Cooling Shroud

1 Turn off the system and attached peripherals. Disconnect the system from

the electrical outlet and periperals.

2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 Hold the touch points on the expansion card stabilizer and lift the

expansion card stabilizer away from the cooling shroud. See Figure 3-6.

5 Hold the touch points on the cooling shroud and lift the cooling shroud

out of the system. See Figure 3-6.

book.book Page 92 Tuesday, June 9, 2009 4:09 PM

Advertising