Dell PowerEdge T410 User Manual

Page 45

Advertising
background image

About Your System

45

Alert! System

fatal error

during previous

boot.

An error caused the system to
reboot.

Check other system
messages for additional
information for possible
causes.

BIOS

MANUFACTURING

MODE detected.

MANUFACTURING

MODE will be

cleared before

the next boot.

System reboot

required for

normal

operation.

System is in manufacturing
mode.

Reboot to take the system
out of manufacturing mode.

BIOS Update

Attempt Failed!

Remote BIOS update
attempt failed.

Retry the BIOS update. If
problem persists, see
"Getting Help" on page 185.

Caution!

NVRAM_CLR jumper

is installed on

system board.

Please run SETUP

NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared.

Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5). See
Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 61.

CPU set to

minimum

frequency.

The processor speed may be
intentionally set lower for
power conservation.

If not an intentional setting,
check any other system
messages for possible causes.

CPU x installed

with no memory.

Memory modules are
required but not installed in
the indicated processor’s
memory slots.

Install memory modules for
the processor. See "System
Memory" on page 106.

Table 1-3.

System Messages (continued)

Message

Causes

Corrective Actions

book.book Page 45 Tuesday, June 9, 2009 4:09 PM

Advertising