Dell PowerEdge T410 - Manual (Page 127)

Installing System Components
127
Integrated Dell Remote Access Controller 6
(iDRAC6) Express Card (Optional)
Installing an iDRAC6 Express Card
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Rotate the system feet inward and lay the system on a flat surface.
3 Open the system. See "Opening the System" on page 90.
4 To install the iDRAC6 Express card:
a Insert the notch on the iDRAC6 Express card into the clip on the
system board.
b Align the front edge of the card with the connector on the system
board. See Figure 6-1 for the location of the connector.
c Press the card down until it is fully seated. See Figure 3-20.
When the front of the card is fully seated, the plastic standoff tab
snaps over the edge of the holder.
5 Close the system. See "Closing the System" on page 91.
6 Place the system upright and on its feet on a flat, stable surface.
7 Rotate the system feet outward.
8 Reattach any peripherals and connect the system to an electrical outlet.
9 Turn on the system and attached peripherals.
book.book Page 127 Tuesday, June 9, 2009 4:09 PM