Removing the i/o panel – Dell Vostro 200 (Mid 2007) User Manual
Page 154
154
Removing and Installing Parts
Removing the I/O Panel
NOTE:
Note the routing of all cables as you remove them so that you can re-route
them correctly when installing the new I/O panel.
1 Follow the procedures in "Before You Begin" on page 101.
2 Remove the computer cover (see "Removing the Computer Cover" on
3 Remove the bezel (see "Removing the Bezel" on page 123).
NOTICE:
When sliding the I/O panel out of the computer, be extremely careful.
Carelessness may result in damage to the cable connectors and the cable routing
clips.
4 Disconnect all the cables that are connected to the I/O panel from the
system board.
5 Remove the screw that secures the I/O panel.
6 Carefully remove the I/O panel from the computer.
1
I/O panel clamp
2
I/O panel
3
screw
4
cables
5
I/O panel clamp slot
1
2
3
4
5
book.book Page 154 Thursday, June 14, 2007 6:23 PM