Dell PowerEdge T105 - Manual (Page 27)

About Your System
27
Reset failed The disk reset
operation failed. See "Troubleshooting a
Diskette Drive" on
page 116 or
"Troubleshooting a Hard
Drive" on page 120.
SATA Port X device not
found.
NOTE:
X is the drive number
(A-D).
Run the system
diagnostics. See
"Running the System
Diagnostics" on
page 127. Also, see
"Troubleshooting a Hard
Drive" on page 120.
Sector not found
Seek error
A faulty diskette drive
or hard drive. See "Troubleshooting a
Diskette Drive" on
page 116 or
"Troubleshooting a Hard
Drive" on page 120.
SMART Failure Predicted
on Hard Disk (SATA
port #)
WARNING: It is
advisable to
immediately back up
your data and replace
your hard-disk drive by
calling your support
desk or Dell Inc.
The Disk Monitoring
System detected an
error, or the SMART
drive function failed. See "Troubleshooting a
Hard Drive" on page 120.
If the problem persists,
see "Getting Help" on
page 137
System Fan was not
detected
The processor cooling
fan is faulty or the fan
assembly is not
installed correctly. Ensure that the
processor cooling shroud
is properly installed. See
"Troubleshooting
System Cooling
Problems" on page 113
and "Microprocessor" on
page 79.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 27 Wednesday, April 15, 2009 8:47 PM