Replacing the i/o panel assembly – Dell PowerEdge T105 User Manual
Page 98
98
Installing System Components
Figure 3-30.
Removing and Installing the I/O Panel Assembly
Replacing the I/O Panel Assembly
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1 Fit the I/O panel assembly so that the holding tab on the front of the
chassis catches at its bottom securing slot and the I/O panel assembly lines
up with the alignment stop. See Figure 3-30.
1
screw on the I/O panel
2
I/O panel assembly
3
alignment stop on chassis
4
I/O panel securing slot
5
holding tab on the chassis
1
4
2
3
5
book.book Page 98 Wednesday, April 15, 2009 8:47 PM