Dell PowerEdge T105 - Manual (Page 95)

Installing System Components
95
4 Close the system. See "Closing the System" on page 47.
5 Reconnect the system to the electrical outlet, and turn on the system.
Bezel (Service Only Parts Procedure)
Removing the Bezel
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 47.
3 Remove the heat sink and shroud assembly. See "Removing the Processor"
on page 79. Do not remove the processor, however.
4 Remove the large processor cooling fan. See "Removing the Cooling Fans"
on page 84.
5 Remove the two bezel release screws. See Figure 3-29.
6 Slide the bezel toward the top of the system, then lift it outward.
book.book Page 95 Wednesday, April 15, 2009 8:47 PM