Dell PowerEdge T105 - Manual (Page 73)

Installing System Components
73
7 Close the card retention door to secure the card(s) in the system.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the
cards can prevent the system cover from closing properly or cause damage to the
equipment.
8 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card’s cable
connections.
9 Close the system. See "Closing the System" on page 47.
10 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
11 Install any device drivers required for the card as described in the
documentation for the card.
SAS Controller Expansion Card
Read the installation instructions in the documentation for your SAS
controller card. Install the card in expansion card connector SLOT1 or
SLOT2 (see "Installing an Expansion Card" on page 72), and connect the
hard-drive activity indicator cable from the card to the AUXLED1 connector
on the system board (see Figure 6-2 for the connector location). Fasten the
cables to the slots as indicated in Figure 3-19 to manage the slack.
book.book Page 73 Wednesday, April 15, 2009 8:47 PM