Dell PowerEdge T105 - Manual (Page 54)

54
Installing System Components
9 Close the system. See "Closing the System" on page 47.
10 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
Installing a Diskette Drive
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 47.
3 Unpack the replacement diskette drive, and prepare it for installation.
4 Check the documentation for the drive to verify that it is configured for
your system.
5 Remove the front drive bezel. See "Removing the Front Drive Bezel" on
page 49.
6 Remove the 3.5-inch insert on the front drive bezel. See "Removing an
Insert on the Front Drive Bezel" on page 50.
7 Remove the four shoulder screws from the back of the insert. See
Figure 3-4; the 3.5-inch insert holds four screws.
8 Attach the four screws to the diskette drive as shown in Figure 3-7.
book.book Page 54 Wednesday, April 15, 2009 8:47 PM