Cisco 10000 - Manual (Page 202)

5-38
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 5 Configuring the Layer 2 Tunnel Protocol Access Concentrator and Network Server
L2TP Network Server
Verifying RADIUS Attribute Accept or Reject Lists
To verify an accept or reject list, enter any of the following commands in privileged EXEC mode:
Caution Because debugging output is assigned high priority in the CPU process, it can render the system
unusable. For this reason, use debug commands only to troubleshoot specific problems or during
troubleshooting sessions with Cisco Systems technical support personnel. Moreover, it is best to use
debug commands during periods of lower network traffic and fewer users. Debugging during these
periods decreases the likelihood that increased debug command processing overhead will affect system
use.
Step 8 Router(config-sg-radius)# exit Exits server-group configuration mode.
Step 9 Router(config)# radius-server attribute
list listname
Defines the list name given to the set of attributes defined using
the attribute command.
Define the listname argument to be the same as you defined it in
step 5.
Step 10 Router(config-sg-radius)# attribute
value1 [value2 [value3...]]
Adds attributes to the configured accept or reject list.
You can use this command multiple times to add attributes to an
accept or reject list.
Command Purpose
Command Purpose
Router# debug aaa accounting Displays information on accountable events as they occur.
Router# debug aaa authentication Displays information on AAA authentication.
Router# show radius statistics Displays the RADIUS statistics for accounting and
authentication packets.