Cisco 10000 - Manual (Page 506)

A-2
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Appendix A RADIUS Attributes
RADIUS IETF Attributes
13 Framed-Compression Cisco 10000 series router ignores this
attribute.
14 Login-IP-Host Not Applicable
15 Login-Service Not Applicable
16 Login-TCP-Port Not Applicable
18 Reply-Message Supported and tested
19 Callback-Number Not Applicable
20 Callback-ID Not Applicable
22 Framed-Route Supported and tested
23 Framed-IPX-Network Not Applicable
24 State Supported but not tested
25 Class Supported and tested
26 Vendor-Specific Supported and tested for Cisco VSA
27 Session-Timeout Supported and tested
28 Idle-Timeout Supported and tested
29 Termination-Action Typically not used in DSL environment
30 Called-Station-ID Typically not used in DSL environment
31 Calling-Station-ID Supported and tested
32 NAS-Identifier Supported and tested
33 Proxy-Stat Not Applicable
34 Login-LAT-Service Not Applicable
35 Login-LAT-Node Not Applicable
36 Login-LAT-Group Not Applicable
37 Framed-AppleTalk-Link Not Applicable
38 Framed-AppleTalk-Network Not Applicable
39 Framed-AppleTalk-Zone Not Applicable
40 Acct-Status-Type Supported and tested
41 Acct-Delay-Time Supported and tested
42 Acct-Input-Octets Supported and tested
43 Acct-Output-Octets Supported and tested
44 Acct-Session-Id Supported and tested
45 Acct-Authentic Supported and tested
46 Acct-Session-Time Supported and tested
47 Acct-Input-Packets Supported and tested
48 Acct-Output-Packets Supported and tested
49 Acct-Terminate-Cause Supported and tested
Table A-1 RADIUS IETF Attributes (continued)
Number IETF Attribute Status