Cisco 10000 - Manual (Page 247)

8-7
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 8 Configuring ATM Permanent Virtual Circuit Autoprovisioning
ATM PVC Autoprovisioning
Example 8-1 creates a VC class named myclass, enables PVC autoprovisioning on the class, and sets the
idle-timeout timer for 300 seconds. The configuration of the idle-timeout timer is optional.
Example 8-1 Configuring a VC Class with PVC Autoprovisioning Enabled
Router(config)# vc-class atm myclass
Router(config-vc-class)# create on-demand
Router(config-vc-class)# idle-timeout 300
Applying the VC Class
To apply a VC class, perform the following tasks:
• Applying a VC Class to an Individual PVC, page 8-7
• Applying a VC Class to a Range of PVCs, page 8-7
• Applying a VC Class to a Specific PVC Within a PVC Range, page 8-8
Applying a VC Class to an Individual PVC
To apply a VC class to a specific PVC, enter the following commands beginning in global configuration
mode:
Example 8-2 applies the VC class myclass to PVC 100/100.
Example 8-2 Applying a VC Class to an Individual PVC
Router(config)# interface atm 3/0/0.1 multipoint
Router(config-subif)# atm pppatm passive
Router(config-subif)# pvc 100/100
Router(config-subif-atm-vc)# class-vc myclass
Applying a VC Class to a Range of PVCs
To apply a VC class to a range of PVCs, enter the following commands beginning in global configuration
mode:
Command Purpose
Step 1 Router(config)# interface atm slot/0
[.subinterface-number {multipoint |
point-to-point }]
Specifies the ATM interface and enters interface or subinterface
configuration mode.
Step 2 Router(config-if)# pvc [name] vpi/vci Specifies the ATM PVC and enters atm-vc configuration mode.
Step 3 Router(config-if-atm-vc)# class-vc
vc-class-name
Applies the VC class on the PVC.
Command Purpose
Step 1 Router(config)# interface atm slot/0
[.subinterface-number {multipoint |
point-to-point }]
Specifies the ATM interface and enters interface or subinterface
configuration mode.