Ieee 1394 device problems – Dell Precision M6300 (Late 2007) User Manual
Page 124
124
Troubleshooting
3
Click Uninstall.
4
See the program documentation for installation instructions.
Windows Vista:
1
Click
Start
→ Control Panel→ Programs→ Programs and Features.
2
Select the program you want to remove.
3
Click Uninstall.
4
See the program documentation for installation instructions.
d r i v e l e t t e r : \
IS
NOT
ACCESSIBLE
. T
HE
DEVICE
IS
NOT
READY
—
The drive
cannot read the disk. Insert a disk into the drive and try again.
I
NSERT
BOOTABLE
MEDIA
—
Insert a bootable floppy disk, CD, or DVD.
N
ON
-
SYSTEM
DISK
ERROR
—
Remove the floppy disk from the floppy drive and
restart your computer.
N
OT
ENOUGH
MEMORY
OR
RESOURCES
. C
LOSE
SOME
PROGRAMS
AND
TRY
AGAIN
—
Close all windows and open the program that you want to use. In some
cases, you may have to restart your computer to restore computer resources. If so, run
the program that you want to use first.
O
PERATING
SYSTEM
NOT
FOUND
—
Contact Dell (see "Contacting Dell" on
IEEE 1394 Device Problems
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTE:
Your computer supports only IEEE 1394a standard.
E
NSURE
THAT
THE
CABLE
FOR
THE
I E E E 1 3 9 4
DEVICE
IS
PROPERLY
INSERTED
INTO
THE
DEVICE
AND
INTO
THE
CONNECTOR
ON
THE
COMPUTER
E
NSURE
THAT
THE
I E E E 1 3 9 4
DEVICE
IS
ENABLED
IN
SYSTEM
SETUP
—
See
"Commonly Used Options" on page 138.
E
NSURE
THAT
THE
I E E E 1 3 9 4
DEVICE
IS
RECOGNIZED
BY
W
INDOWS
—
Windows XP:
1
Click Start and click Control Panel.
2
Under Pick a Category, click Performance and Maintenance
→
System
→
System
Properties
→
Hardware
→
Device Manager.
Windows Vista:
1
Click
Start
→ Control Panel→ Hardware and Sound.
2
Click Device Manager.
book.book Page 124 Wednesday, August 13, 2008 12:12 PM