Dell Precision M6300 (Late 2007) - Manual (Page 157)

Adding and Replacing Parts
157
1 Ensure that the work surface is flat and clean to prevent the computer
cover from being scratched.
2 Turn off your computer (see "Turning Off Your Computer" on page 155).
3 If the computer is connected to a docking device (docked), undock it. See
the documentation that came with your docking device for instructions.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer
and then unplug the cable from the network device.
4 Disconnect all telephone or network cables from the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery
before you service the computer.
5 Disconnect your computer and all attached devices from their electrical
outlets.
6 Close the display and turn the computer over on a flat work surface.
7 Remove the main battery:
a Slide the battery-bay latch release on the bottom of the computer.
1 battery-bay latch release 2 main battery
1 2
book.book Page 157 Wednesday, August 13, 2008 12:12 PM