Crestron electronic One-Gang 802.11a/b/g Wireless Access Point CEN-WAP-ABG-1G - Manual (Page 12)

802.11a/b/g Wireless Access Point Crestron CEN-WAP-ABG-1G
Setup
Network Wiring
When wiring the Ethernet network, use CAT5 wiring. CAT5 wiring is a twisted pair
cable designed for Ethernet networks. These networks operate at speeds of up to 100
Megabits per second (Mbps) using the 100BaseT standard.
For information on connecting Ethernet devices in a Crestron system, refer to the
latest version of the Crestron e-Control
® Reference Guide (Doc. 6052), which is
available for download from the Crestron website ( www.crestron.com/manuals ).
Supplied Hardware
The hardware supplied with the CEN-WAP-ABG-1G is listed in the following table.
Supplied Hardware for the CEN-WAP-ABG-1G
DESCRIPTION PART NUMBER QUANTITY
2.4/5.8 GHz White Omnidirectional
Antenna 2021159 1
6-Foot CAT5e Patch Cable 2021160 1
#6-32 x ¾”, Pan Head Phillips Screws 2022188 2
Installation
Ventilation The CEN-WAP-ABG-1G should be used in a well-ventilated area. The venting holes
should not be obstructed under any circumstances. Contact with thermal insulating
materials should be avoided on all sides of the device. If installing the access point
in an insulated wall, one inch of insulation must be removed from all sides of
the device.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications.
8 • 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G Operations & Installation Guide – DOC. 6695B