Crestron electronic One-Gang 802.11a/b/g Wireless Access Point CEN-WAP-ABG-1G - Manual (Page 22)

802.11a/b/g Wireless Access Point Crestron CEN-WAP-ABG-1G
Configuring Basic Setup Settings
Basic setup settings allow you to configure the following:
• TCP/IP addressing
• Operational mode
• DHCP server settings
Configuring TCP/IP
Addressing To configure TCP/IP addressing, click the BASIC SETUP tab and then click the
TCP/IP CONFIG subtab. The “TCP/IP Addressing” page opens.
“TCP/IP Addressing” Page
Refer to the configuration guidelines that follow.
Connection type: From the drop-down list, select either of the following:
• Automatic Configuration – DHCP: (Default setting) Allows the IP
address of the access point to be automatically assigned by a DHCP
(Dynamic Host Configuration Protocol) server on the local area network
(LAN) for a predetermined period of time.
• Static IP: Allows you to manually set a permanent IP address for the
access point as well as additional settings:
IP address: Enter a unique IP address for the access point.
Subnet mask: Enter the subnet mask that is set on your network.
NOTE: A class C network allows up to 255 devices to communicate
without a router and has a subnet mask of 255.255.255.0. A class B network
allows up to 65,535 devices to communicate without a router and has a
subnet mask of 255.255.0.0.
Default router: Enter the IP address of your network’s device (usually a
router) that enables communication between your network and the Internet.
18 • 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G Operations & Installation Guide – DOC. 6695B