Crestron electronic One-Gang 802.11a/b/g Wireless Access Point CEN-WAP-ABG-1G - Manual (Page 20)

802.11a/b/g Wireless Access Point Crestron CEN-WAP-ABG-1G
4. Click Next. The “Setup Complete” page opens as shown in the following
example.
“Setup Complete” Page (802.11b/g Configuration Profile Shown)
5. Review the settings and, if appropriate for your wireless network, click
Apply Setting. (If not appropriate, go back to the “Select Configuration”
page and select a different configuration profile.)
NOTE: When you click Apply Setting, the “Setup Complete” page opens.
The access point restarts to allow the settings to take effect (about 25
seconds).
6. Connect your touchpanel to the access point by clicking the appropriate
touchpanel (for example, TPMC-8X, TPMC-4X, or TPMC-10) and by
following the on-screen instructions provided by the wizard. If your
touchpanel is not listed, refer to the manual included with the touchpanel for
instructions to connect the touchpanel to the access point.
Using Custom Settings Configuration Mode
Custom Settings configuration mode allows you to do the following:
• Configure basic setup settings
• Configure wireless network settings
• Configure administrative settings
• View and monitor operational status
To access Custom Settings configuration mode, open the Home page and click
Custom Settings.
16 • 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G Operations & Installation Guide – DOC. 6695B