Crestron electronic One-Gang 802.11a/b/g Wireless Access Point CEN-WAP-ABG-1G - Manual (Page 37)

Crestron CEN-WAP-ABG-1G 802.11a/b/g Wireless Access Point
RADIUS accounting port: Enter the accounting port number of the RADIUS server.
The default setting is 1813.
NOTE: The RADIUS accounting port is officially assigned to UDP port 1813.
RADIUS servers of Microsoft Corporation default to port 1813; however, RADIUS
servers of Juniper Networks, Inc. and Cisco Systems, Inc. default to port 1646.
Shared key: Enter a secret key to be shared by the access point and the RADIUS
server so that they can authenticate each other. Valid characters are 0 to 9, a to f, and
A to F. Note that the shared key is case sensitive.
Network Access Server (NAS) Identifier: Enter a unique NAS identifier to identify
the access point in addition to its IP address. The default setting is Crestron.
Configuring Administration Settings
Administration settings allow you to do the following:
• Assign a new user name and password
• Upgrade the firmware of the access point
• Restore previous configuration settings of the access point
• Back up current configuration settings of the access point
• Restore factory default settings of the access point
• Configure external control settings (for example, enable or disable the front
Ethernet port)
Configuring User Name and
Password Settings To configure user name and password settings, click the ADMINISTRATION tab and
then click the PASSWORD subtab. The “Password” page opens.
“Password” Page
Refer to the configuration guidelines that follow.
Operations & Installation Guide – DOC. 6695B 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G • 33