Crestron electronic One-Gang 802.11a/b/g Wireless Access Point CEN-WAP-ABG-1G - Manual (Page 5)

Crestron CEN-WAP-ABG-1G 802.11a/b/g Wireless Access Point
802.11a/b/g Wireless Access
Point: CEN-WAP-ABG-1G 802.11a/b/g Wireless Access
Point: CEN-WAP-ABG-1G
Introduction Introduction
The CEN-WAP-ABG-1G wireless access point enables wireless communication for
Crestron
® Wi-Fi touchpanels, 2-Series control systems, computers, and other
devices. With IEEE 802.11a/b/g support, easy setup, flush-mount installation, and
enterprise level security and management capabilities, the CEN-WAP-ABG-1G
delivers an ideal wireless access point solution for any application.
Features and Functions
• Supports 802.11a, 802.11b, and 802.11g protocols
• Single-wire hookup using Power over Ethernet (PoE)
• Secure network with no configuration required
• Web-browser configuration and management
• Enterprise level security
• Built-in DHCP server
• MAC address filtering
• On-board event logging
• SNMP and UPnP configuration and management
• Bridge mode for wireless LAN-to-LAN capability
• Ethernet control system interface
• Front-panel LAN pass-through port
• Attractive Decora
® flush-mount design
Single-Wire Hookup
Power over Ethernet (PoE) capability powers the CEN-WAP-ABG-1G through the
LAN wiring, eliminating the need for a separate power supply. A Category 5 (CAT5)
cable simply connects the wireless access point to a PoE injector (PWE-4803RU),
allowing for installation at a convenient location apart from the access point.
Alternatively, using the Crestron five-port PoE switch (CEN-SW-POE-5), up to four
access points can be powered from a single location, simplifying design and wiring.
A third-party PoE source device can also be used to power the access point.
Operations & Installation Guide – DOC. 6695B 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G • 1