Two Brothers Racing BMW S1000RR User Manual

V.a.l.e, S1000rr, 2010 bmw

Advertising
background image

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

Installation Instructions

1.

Make sure the bike is completely cool before starting

the installation. Make sure the bike is secure on a

stand or ideally a service lift.

2.

Remove OEM muffler assembly.

3.

Attach TBR muffler to supplied slip-on tube using the 4

socket head cap screws and thread-lock provided.

4.

Install TBR muffler assembly to bike, use supplied nut

with OEM bolt on muffler bracket mount.

5. Check alignment and then tighten muffler mount

bolt and finally barrel clamp.

6. Before you run the bike, clean off all fingerprints

and dirt, as any oily residue will etch the metal and

become somewhat permanent when the system

gets hot. Also, remove any protective plastic from

the name badges on the muffler canister(s) or the

muffler clamp(s). Run the bike and enjoy. It is normal

for some white smoke to appear the first time you

start the bike. This is packing/manufacturing oil from

inside the pipe burning off. After 50 to 100 miles,

recheck all fasteners for tightness.

2010 BMW

S1000RR

Slip-on Exhaust System
Part# 005-2810406V-B / 005-2810407V-B / 005-2810408V-B

Parts List

IMPORTANT - PLEASE READ CAREFULLY

Warranty

two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as

is” without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a

particular purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising

from the use of these products or parts.

Qty.

Description

Part Number

1

Muffler Canister

Varies

1

Slip Tube

005-28104S

1

HARDWARE KIT

005-281-3

4

6x20mm Socket Head Cap Screws

005-SH620

1

8mm Flange Nut

005-FN8

1

5mm Long Handle Ball End Hex Key

005-9-18610

1

T20 Torx Hex Key

005-9-15820

1

TBR Sticker Kit

015-10212

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance

part, please consult with your local motorcycle dealer. Read all instructions first

before starting installation. Make sure the motorcycle and exhaust system are

completely cool before starting the installation. Also, make sure the bike is secure

on a centerstand or ideally a service lift during installation. Be sure to save all stock

components for possible use later.

**This product has not been tested with all available accessories and some

items may cause excessive heat. Excessive heat may cause damage to your

vehicle. Two Brothers Racing will not be responsible for damaged parts.

Advertising