Two Brothers Racing BMW K1300S - Manual

V.A.L.E.
V A R I A B L E A X I S L O C K I N G E X H A U S T
TM
Installation Instructions
1. Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on a
centerstand or ideally a service lift.
2. Remove heat shield.
3. Loosen muffler joint clamp.
4. Remove muffler mounting bolt.
5. Install TBR slip-on tube to TBR muffler using the
supplied socket head cap screws, lockwashers and
X-Ring provided. Leave loose for now.
6. Slide rubber lined muffler clamp over TBR muffler.
7. Install TBR muffler assembly to motorcycle using the
OEM hardware. Leave loose for now.
8. Align muffler and tighten muffler joint clamp.
9. Tighten X-Ring bolts in a cross pattern.
10. Tighten muffler mounting strap.
11. Remove clip-nuts from OEM muffler assembly and
install on TBR slip-tube.
12. Re-install OEM heat shield.
13. Double check to make sure that all hardware is
tightened.Carefully double check your work to
insure that all hardware is securely fastened. If you
are using bags on motorcycle make sure you have
adaquate clearance between muffler and bags to
keep from causing damage, this is not covered
under warranty.
14. Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system
gets hot. Also, remove any protective plastic
from the name badges on the muffler canister(s)
or the muffler clamp(s). Run the bike and enjoy.
It is normal for some white smoke to appear
the first time you start the bike. This is packing/
manufacturing oil from inside the pipe burning
off. After 50 to 100 miles, recheck all fasteners for
tightness.
2009-15 BMW
R1300S
Slip-On Exhaust System
Part # 005-2650406V / 005-2650407V / 005-2650408V
Parts List
IMPORTANT - PLEASE READ CAREFULLY
Warranty
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
exhaust system are completely cool before starting the installation. Also,
make sure the bike is secure on a centerstand or ideally a service lift during
installation. Be sure to save all stock components for possible use later.
Qty. Description Part Number
1 Muffler Canister Varies
1 Muffler Canister Clamp Varies
1 Stainless Steel S-bend Tube 005-26504S
1 HARDWARE KIT 005-265-3
1 X-Ring Kit 005-7-2-3KIT
4 6x14mm Socket Head Cap Screws 005-SH614
1 TBR Sticker Kit 015-10212