Two Brothers Racing BMW S1000RR - Manual

V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Installation Instructions
1. Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on a
stand or ideally a service lift.
2. Remove seat.
3. Remove left and right upper and lower fairings.
4. Carefully remove crossover servo cable. Do not turn
servo wheel (damage may occur if you do). Keep
servo plugged in. This servo is located on left side of
motorcycle at the lower front of fuel tank.
5. Remove/lift fuel tank to access second servo, located
under rear of fuel tank.
6. Remove both cables from servo carefully. Do not
turn servo, the servo must stay plugged in and on
motorcycle.
7. Remove muffler mounting bolt and inside spacer,
these will not be re-used.
8. Loosen joint clamp and remove muffler assembly.
9. Remove cables from motorcycle being careful not to
damage or scratch the bike.
2010 BMW
S1000RR
Full Exhaust System
Part# 005-2810106V-B / 005-2810107V-B / 005-2810108V-B
Parts List
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as
is” without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a
particular purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising
from the use of these products or parts.
Qty. Description Part Number
1 Muffler Canister Varies
1 Header Kit 005-28101HK
1 Slip Tube 005-28101S
1 Canister Clamp Varies
1 HARDWARE KIT 005-281-3C
4 6x20mm Socket Head Cap Screws 005-SH620
4 6mm Lock Washers 005-WL6
2 X-Ring (half) 005-7-2-3
2 8mm Flange Nut 005-FN8
1 8x45mm Flat Head Socket Cap Screw 005-SHF845B
1 66mm Barrel Clamp 005-27-66MSH
1 Decorative Countersunk Washer 005-WA8-B
1 8x25mm Hex Bolt 005-HB825
1 Mounting Bracket 005-281-B2
1 22mm Black AL Spacer 005-S-22A
1 5mm Long Handle Ball End Hex Key 005-9-18610
1 T20 Torx Hex Key 005-9-15820
1 TBR Sticker Kit 015-10212
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.
**This product has not been tested with all available accessories and some
items may cause excessive heat. Excessive heat may cause damage to your
vehicle. Two Brothers Racing will not be responsible for damaged parts.