Two Brothers Racing Can-Am Spyder Spyder RT User Manual
Page 5
Advertising
TBR001-283
www.twobros.com
10-11 Spyder RT
Posi tap
TPS
FIG
.G
FIG
.H
FIG
.J
12 Plug the YELLOW colored wires from the Juicebox Pro in-line of the stock
wiring harness and injector.
13 Unplug the stock wiring harness from the injector on the right hand side
(Fig. H).
This connection is located to the Right, Rear of the air box.
14 Plug the ORANGE colored wires of the Juicebox Pro in-line of the stock wiring
harness and injector.
15 Locate the Throttle Position Sensor on the left
side of the throttle bodies.
16 Use the supplied Posi-tap attach the GREY wire
of the Juicebox Pro to the WHT/BRN wire of the
TPS wiring harness.
Figure J is shown with the TPS harness
disconnected from the sensor. Make sure to
reconnect the harness to the sensor.
Advertising