Two Brothers Racing Can-Am Spyder Spyder RS User Manual
Page 3
Advertising
ITBR001-229
2008-10 CanAm Spyder - 3
Fi
gu
re
A
Fi
gur
e B
Fi
gu
re
C
remove covers
air box cover
remove bolts
remove bolt
The ignition must be turned OFF before installation.
1
Remove the cosmetic covers on both the right and left sides as shown in Figure A.
2
Release the clips around the edge of the air box cover and remove the cover as
shown in Figure B.
3
Remove the six bolts securing the air box base and remove the base as shown in
Figure C.
Only four bolts are visible in Figure C.
4
Cut the three zip ties on the left side of the air box securing the wiring harness.
5
Pull the air box base out the right side.
This will allow access to the injector connectors.
Advertising