Two Brothers Racing Yamaha Super Tenere User Manual
Page 3
ITBR001-312 www.twobros.com
2011-2012 Yamaha XTZ1200 - 3
1. Remove the seat.
2. Remove both the left and right side panels.
3. Prop the front of the fuel tank up.
4. Place the Juice Box Pro on the right side of the bike near the battery as shown in
Figure A.
5. Attach the Juice Box Pro ground wire to the negative side of the battery as shown
in Figure A.
Using the stock zip tie, secure the Juice Box Pro harness to the main harness.
6. Route the Juice Box Pro harness along the stock
main harness, under the frame tube, and to the
throttle body as shown in Figure B.
7. Locate the Throttle Position Sensor (TPS) connector
as shown in Figure B.
The TPS connector is located on the right side of the
throttle bodies.
8. Using the supplied posi-tap, connect the grey wire
from the Juice Box Pro to the stock white wire as
shown in Figure B.
9. Using the stock zip tie, secure the Juice Box Pro
harness to the main harness.
10. Unplug the stock wiring harness from each injector as shown in Figure C.
FIG
.A
FIG
.B
FIG
.C
posi-tap
harness
harness