Sony MDS-501 - Manual (Page 22)

Pausing After Each
Track (Auto Pause)
wtswrumy g
Before Recording
When the auto pause function is on, the recorder pauses
after playing each track. To continue playing, press PAUSE.
Auto pause is convenient when recording single tracks or
multiple, non-consecutive tracks.
Remote commander operation only
op Çp ^p
cp
Cp QD
GD Qp (p
QD (S (S (S
■A.SPACE
Mwwoacwicoaot»*"
Press A. SPACE twice.
"A.PAUSE"Ughtsup.
Selecting the recording mode
By selecting the recording mode, you can specify whether
existing material on an MD is erased or not when you begin
recording immediately after inserting an MD. The two
available modes are described below;
All REC OFF — The recorder saves the contents of
the MD and starts recording from
the end of the existing materiai.
This mode allows you to record from
the end of existing materiai without
searching for the ending position.
All REC ON — The recorder erases the contents of
the MD and starts recording from the
beginning of the MD. This mode
allows you to quickly record over the
entire contents of a previously
recorded MD.
All REC OFF is the factory setting. To change the recording
mode to All REC ON, follow' the procedure below before
inserting an MD into the recorder.
1 2 41n 21s
To cancel the auto pause function
Press A.SPACE again to turn off "A.PAUSE"
I Notel
Pausing in the middle of selections
When a selection comprises consecutive tracks undivided by blank
spaces (e.g., symphonies), the auto pause function may cause the
recorder to pause at the start of each track within the selection.
22