Sony MDS-501 - Manual (Page 42)

Labeling Recordings (Title Function)
(Continued from previous page)
Turn the AMS dial to select the first
character.
лт m m m I
Letters, numbers, and symbols appear in
sequential order as you turn the AMS dial.
The following symbols can be used in titles:! " #
$ % & ' ( ) » + , - . / : ; < = > ? @ i ¥ l ' ' _ ' l | } -
Note, however, that the symbols {¥ J { |} ~ may not
be supported on certain MD recorder models.
4
Press the AMS dial to enter the selected
character.
The cursor shifts rightward and waits for input
of the next character.
в 1 4 • • г е е »
n t t » M »
» t ? »
Repeat steps 3 and 4 until you have
entered the entire title.
If you entered the wrong character
Press
« or ►► to move the flashing cursor
under the character to be corrected, and repeat
steps 3 and 4 to enter the correct character.
To erase a character
Press »d or ►► to move the flashing cursor
under the character to be erased, then press
EDIT/NO.
To enter a space
Press the AMS dial or I
6
Press YES.
When the labeling procedure has been
completed, the title appears on the left side of the
display window.
DIflRV
4 • • T e e »
h t t » M •
» « Г »
42
Labeling an MD with the front panel
controls
After inserting the MD to be labeled, use the prcKodure
below to label the MD with the front panel controls.
1 Keep pressing EDIT/NO while the recorder is
stopped until "Name in ?" lights up.
2 Repeat steps 2 to 6 of "Labeling a track with
the front panel controls" on pages 41 and 42.
To cancel the title function
Press ■.
Erasing all track titles on a disc
1
Hold down EDIT/NO while the recorder is stopped until
"All Erase ?" lights up.
2 Press EDIT/NO again until “Name Erase?” lights up.
3 Press YES.
I Notes I
If the "Protected" indication lights up
The recorder could not label the specified track because the reci>rd-
protect slot on the disc is open. Label the track after closing the slot.
When "TOC" flashes in the display window
Do not jog the recorder or pull out the power cord. After the
recorder updates the contents of the recording, "TOC" lights up. If
You've made any changes to the MD, "TOC" lights up. If you press
EJECT or TOWER at this time, 'TOC" flashes as the actual
contents of the MD are updated.