Sony MDS-501 - Manual (Page 29)

7
Press ^ or II.
Recording pause is canceled and recording starts.
ZD o r
The track number and elapsed recording time (in
minutes and seconds) of the track being recorded
appear.
4 0 0 n 0 1 s
=9^
’ I I ” goes off.
8
Restart the sound source to be recorded.
9 Press ■ to stop recording.
Recording stops.
]
To check the remaining time on the disc
Press DISPLAY (see page 26).
To pause recording
Pre^ II.
Press ► or II again to restart recording.
The track number increases by one each time you pause
recording.
To eject a disc
Press ^ EJECT.
Using EDIT/NO to specify track marking
Press EDIT/NO during recording or recording pause to
specify manual or automatic track marking. For details, see
"Writing Track Numbers While Recording (Track Marking)"
on page 32.
Adjusting the recording level
When recording sound sources through the line (analog)
input jack, use the REC LEVEL control to adjust the
recording level.
1
Press • REC (•) to change the recorder
to recording pause.
Piay the sound source to be recorded.
Whiie monitoring the sound through the
headphones, adjust the recording levei
with the REC LEVEL controi.
Adjust the recording level so that the peak level
meter reaches its highest point with the least
intrusion into the red (OVER) zone.
The outer knob controls the L (left) channel level
and the inner knob the R (right) channel level.
You can adjust the knobs together, or
independently by turning one knob while
holding the other.
4 R E C R e a d y
4
Press ^ or II to start recording.
I Notes I
When "TOC” flashes in the display window
Do not jog the recorder or pull out the power cord.
If "Protected" appears in the display window
The disc is record-protected. Qose the slot to record on the disc (see
page 24).
29