Speaker system hookup – Sony STR-DB940 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Speaker System Hookup
S
5
;
5'
in
€
3
a
lA
I
i
lA
■o
m
ftp
VI
»<
w
s
3
ccNmds
Speaker cords (not supplied)
One for each front, rear, and center speaker
Monaural audio cord (not supplied)
One for an active sub woofer
Black Oct
Temiinals for o»nn«<ting the speakei«
Connect the
To the
Front speakers (8 or 4* ohm)
SPEAKERS FRONT A terminals
Additional pair of front
speakers (8 or 4* ohm)
SPEAKERS FRONT B terminals
Rear speakers (8 or 4* ohm)
SPEAKERS REAR terminals
Center speaker (8 or 4* ohm)
SPEAKERS CENTER terminals
Active sub woofer
SUB WOOFER PRE OUT**
* See "Speaker impedance" on the next page
** You can connect an active sub woofer to either of the two jacks The
remaining jack can be used to connect a second active sub woofer.
9 To connect certain speakers to another amplifier
Use the PRE OUT jacks The same signal is output from both the
SPEAKERS jacks and the PRE OUT jacks For example, if you
want to connect just the front speakers to another amplifier,
connect that amplifier to the PRE OUT FRONT L and R jacks
Holes on s|»eaker system hookup
• Twist the stripped ends of the speaker cords about
2/3 inch (10 mm) Be sure to match the speaker cord to
the appropriate terminal on the components: + to + and
- to - If the cords are reversed, the sound will be
distorted and will lack bass
• If you use front speakers with low maximum input
rating, adjust the volume carefully to avoid excessive
output on the speakers
16