Selecting a sound field, 2ch stereg ^a.f.d. analog direct normal surround – Sony STR-DB940 User Manual
Page 79
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Selecting a Sound Field
If you selected the tape deck
Move the easy scroll key to display the information about
deck A or B
Note
When the remote is programmed to control a non-Sony tape
deck, the following may occur:
— The information about deck B is not displayed and you
carmot switch between tape deck A and B
— "TAPE A / B" is displayed and tape deck A and B switch
automatically each time you press the easy scroll key, etc
If you selected the 2ND AUDIO source
Move the easy scroll key to select the source of 2ND
AUDIO, then press the key
Note
Depending on the component you are using, "2ND AUDIO" may
not be displayed
Do the procedure below to select a sound field from the
sound field list Note that the sound fields contained in
each list will vary depending on the receiver
1
Press SOUND FIELD
The sound field list appears
2CH STEREG
^A.F.D.
ANALOG DIRECT
NORMAL SURROUND
I
2
Move the easy scroll key to select the sound field,
then press the key to enter the selection
A display example
3
IS
NORMAL SURROUND
CINEMA ST.EX.A
CINEMA ST.EX.В
^CINEMA ST.EX.C
To turn off the sound field
Move the easy scroll key to select either "2CH STEREO"
or "A F D " in the sound field lisf in the display The
sound field list that is displayed is different depending on
the model
15